Tag - eigrp protocol

CCNA – EIGRP Questions
Short Question of CCNA OSPF

CCNA – EIGRP Questions

Here you will find answers to EIGRP Questions

Question 2:

As a Cisco technician, you need to know EIGRP protocol very well. Which of the following is true about EIGRP successor routes? (Choose two)

A – A successor route is used by EIGRP to forward traffic to a destination
B – Successor routes are stored in the neighbor table following the discovery process
C – Successor routes are flagged as “active” in the routing table
D – A successor route may be backed up by a feasible successor route

Answer: A D


B is not correct because neighbor table only contains a list of directly connected EIGRP routers that have an adjacency with this router, it doesn’t contain successor routes.

C is not correct because successor routes are not flagged as “active”, they are always the best route to reach remote networks and are always used to send packets.

A and D are correct because successor route is the best and primary route to a remote network. It is stored in the routing table and topology table. If this route fails, a backup route (called feasible successor route) in the topology table will be used to route traffic to a destination.

Question 3:

Which two statements are true regarding EIGRP? (Choose two)

A – Passive routes are in the process of being calculated by DUAL
B – EIGRP supports VLSM, route summarization, and routing update authentication
C – EIGRP exchanges full routing table information with neighboring routers with every update
D – If the feasible successor has a higher advertised distance than the successor route, it becomes the primary route
E – A query process is used to discover a replacement for a failed route if a feasible successor is not identified from the current routing information

Answer: B E


Diffusing Update Algorithm (DUAL) is the algorithm for selecting and maintaining the best path to each remote network. DUAL tracks all the routes advertised by neighbors and selects routes based on feasible successors. It inserts lowest cost paths into the routing table (these routes are known as primary routes or successor routes) -> A is not correct.

EIGRP is still a distance-vector protocol, but has certain features that belong to link-state algorithms (like OSPF) than distance-vector algorithms. For example, EIGRP sends a partial routing table update, which includes just routes that have been changed, not the full routing table like distance-vector algorithms -> C is not correct.

The feasible successor route will become the primary route when its advertised distance is higher than the feasible distance of the successor route. The feasible successor route can be used in the event that the successor route goes down. Notice that the feasible successor route does not get installed in the routing table but is kept in the topology table as a backup route -> D is not correct.

“Support VLSM, route summarization, and routing update authentication” are the features of EIGRP -> B is correct.

When a route fails and has no feasible successor, EIGRP uses a distributed algorithm called Diffusing Update Algorithm (DUAL) to discover a replacement for a failed route. When a new route is found, DUAL adds it to the routing table -> E is correct.

Short Question of CCNA OSPF

123- On which bas OSPF take decision?


124- What is default cost of serial interface in OSPF?


126- How many types of OSPF Configuration?

There are Two Types



127- What is hold down time formula of OSPF?


128 – What is the default bandwidth size of T1 Routers?


129- If bandwidth will increase what will happen?


130- What is the command for change serial cost?

IP OSPF COST (which want to set)

131- When DR communicate with BDR which multicast ip it use ?

132- What is the draw back of OSPF protocol?

i) Single Area

ii) High Hardware Requirements

iii) Troubleshooting

133- Which protocol comes under Hybrid dynamic type?


134- Which protocol works only on Cisco routers?


135- What is the size of Hello Packets in EIGREP protocol?


136- How much hold down time of EIGREP protocol?


137- Formula of Hold down time of EIGRP protocol?


138- After how long EIGRP protocol Advertise its routing table?


139- Which multicast IP EIGRP protocol use?

140- Which protocol called Rapid protocol?


141-What is the name of Algorithm of EIGRP protocol?


142- How many hop counts are by default and how much you can increase in EIGRP protocol?

By default 100 counts, and maximum 25

143- How much internal and External AD of EIGRP protocol?

Internal =90 and Externa =170

144- What is the name of best path in EIGRP protocol?


145- What is the second best path name of EIGRP?


CCNA Interview Question Part 1

CCNA Interview Question Part 2

CCNA Interview Question Part 3

CCNA Interview Question Part 4

CCNA Interview Question Part 5

CCNA Interview Question Part 6

CCNA Interview Question Part 7

CCNA Interview Question Part 8

CCNA Interview Question Part 9

CCNA Interview Question Part 10

CCNA Interview Question Part 11

CCNA Interview Question Part 12

CCNA Interview Question Part 13

CCNA Interview Question Part 14

Copyright © 2024. Created by IT Learning. Powered by DumpsForAll | Terms of Use | Privacy Policy